Ultraflex Group

In-line silencers - LLOYDS Approved

In-line silencers - LLOYDS Approved Silencing and exhaust systems HALYARD® - Silencing and exhaust systems

In-line silencers - LLOYDS Approved

UP TO 50% NOISE REDUCTION
Halyard® in-line silencers are used where the engine is well above the water-line, or where a high-riser has been fitted to achieve a 1 in 8 gradient from the engine to the transom outlet. They are simple to specify and fit, and ideally need to be 0,5m to 1m behind the engine. The internal design requires the exhaust gasses and water to bubble through a layer of water on the bottom of the silencer to reduce noise. They offer excellent noise reduction and are widely used on both pleasure and commercial engines.


ROUND IN-LINE SILENCERS
These silencers are made from enormously strong filament wound tube, giving the maximum possible protection if the exhaust back-fires. Every unit is pressure tested before being gel-coated. They must be
installed within 5 degrees of horizontal.

OVAL IN-LINE SILENCERS
Our oval silencers are hand-moulded for use where the round body unit cannot be accommodated. They give the same excellent results and every single unit is pressure tested and gel-coated. The inlets can
be angled to ease the connection to the engine and positioned on the end or the side.