Ultraflex Group

outboard inboard sterndrive engine installation steering cables for boats nautical sector pumps

Selection of engine control cables Engine control cables MECHANICAL SYSTEMS FOR ENGINE CONTROLS

Selection of engine control cables

For new installation measure A + B distance from the control along an unobstructed cable routing to clutch and / or throttle connection.
Round this dimension off to the next whole foot: you will have your cable length.
We recommend that the cable bends have a minimum radius of about 8” (200 mm).
For outboard engine installations, it is necessary to add three feet to the obtained length, in order to allow the engine movement.
To determine the needed length of the REPLACEMENT CABLE, measure it from tip to tip.
When ordering, specify the cable length in feet, rounding the dimension off to the next whole value.

 

SELECTION OF ENGINE CONTROL CABLES
ENGINE ULTRAFLEX ENGINE CONTROL CABLES

OUTBOARD
Mercury® Scatole Gen. II™ C36 - MACH36

Mercury®

Mariner® oltre 50 hp (37kW)

C5 - MACH5
Mariner® fino a 50 hp (37kW) C16

Force®

Selva®

Yamaha®

Suzuki®

Tohatsu®

Honda®

Nissan®

C2 - C8 - MACHZero
Johnson® - Evinrude® - BRP® after 1979 C14-MACH14
JET Weber® C40 - C41
STERNDRIVE Mercruiser® Scatole Gen. II™ C36 - MACH36
Mercruiser® C5 - MACH5
OMC® - BRP® after 1979 C14-MACH14

Volvo Penta®

Yanmar®

Volkswagen®

C2 - C8

MACHZero - C22

INBOARD   C2 - C8 MACHZero - C22
OUTBOARD
A + B + 3´ (90 cm) = L
INBOARD/STERNDRIVE
A + B = L